Filter
Top Products
Drip tray
There is a sensor in the drip tray which
causes a message to appear in the
display when the drip tray is full and
needs to be emptied. Remove the tray
and empty and clean it when this
message appears.
However, to avoid a build-up of odours,
the drip tray should be cleaned every
day.
After running the last rinse you
should leave the drip tray in position
for a while before cleaning it so that
you catch any remaining water from
the system.
Take care when removing the drip
tray as the water can be very hot.
Danger of scalding.
^ Open the machine front, and
carefully remove the drip tray from
the machine.
The grid in the drip tray prevents the
water from spilling out of the tray
when it is being carried.
^
Clean the drip tray and the grid with
hot water and a little washing-up
liquid, or in the dishwasher and dry
with a cloth.
Make sure that the metal contact
discs at the top of the drip tray are
cleaned and dried properly. These
metal discs send a signal to the
machine when the drip tray is full or
if it is not in the machine. The discs
will not convey these messages if
they are dirty or damp.
^ Push the drip tray with the grid along
the right hand edge back into the
machine.
^
Close the front of the machine.
Cleaning and care
45