Filter
Top Products
. . . the machine does not switch on
even though the "Switch on at"
setting for the timer has been
activated.
The system lock has been activated.
^
Deactivate it. (See "Settings:
customising your machine - Safety
(activating the System lock)").
The machine was not used after being
switched on automatically 3 times in
succession.
^
Switch the machine on and make a
drink.
. . . you cannot read the display.
If the machine is installed too low down,
the display can be hard to see.
^ Try to improve this by adjusting the
display contrast or brightness (see
"Settings: customising your machine -
Setting the display").
. . . you cannot open or close the
front of the machine.
The steam valve is not in the correct
upward facing position.
^
Push the steam valve right down to
start with, and then pull it upwards as
far as it will go.
. . . the time of day needs to be reset.
The time of day needs to be reset if the
machine has been switched off with the
master switch or at the wall socket. Any
times programmed for switching on or
off automatically remain in memory and
do not need to be reset.
. . . drinks are not dispensed, even
though the coffee capsules are in the
capsule carousel and there is
sufficient water in the water
container.
The water container has not been
correctly positioned inside the machine.
^ Remove the water container and
replace it.
A coffee capsule has jammed in the
capsule carousel.
^ Open the front of the machine.
^ Pull the carousel runners out, lift the
capsule carousel upwards and
release the coffee capsules so that
they can move without hindrance.
^
Replace the capsule carousel on its
runners, and push the runners as far
as they will go into the machine.
^
Close the front of the machine.
Problem solving guide
56