Filter
Top Products
. . . the coffee is too weak.
^
Make sure that the amount of water
programmed is not too much for the
coffee.
^
Check to see how many coffees have
already been dispensed (see
"Settings: Customising your machine
- Info (showing the number of
drinks)").
If the amount of water is correct, and
approx. 15,000 coffees have already
been dispensed, you will need to
replace the capsule hopper in the
brew unit (see "Cleaning and care -
Maintenance").
. . . there is water in the waste
container.
This is not a fault. The water is left over
from the brewing and cleaning process.
. . . there is residual "coffee water" in
the waste container.
The capsule plate is not pushed in
correctly.
^
Remove the capsule plate and push
it back in correctly.
. . . the descaling programme was
started by mistake.
The descaling programme cannot be
cancelled once you have touched the
OK sensor. The programme has to be
completed through to the end. This is a
safety measure to ensure that the
machine is fully descaled, and is
important for the long-term protection of
the machine and to ensure it functions
correctly.
^
Descale the machine (see "Descaling
the machine").
. . . the heating-up time is getting
longer, the amount of water coming
through is incorrect and the machine
is not performing properly.
The machine needs descaling.
^
Descale the machine (see "Descaling
the machine").
. . . the fault message "Push water
container right in" appears.
Water has not been taken in.
^ Perhaps the system was not filled
with water before the first drink was
made. Fill the system with water as
described in "Making drinks: Before
preparing the first drink - Filling the
system with water".
The water container has not been
correctly positioned inside the machine.
^
Remove the water container and
replace it.
^
This error message also appears if
the water container was not correctly
filled for descaling. Fill the container
to the mark, and start the descaling
process again.
If this fault message continues to
appear in the display, please call the
Miele Service department, quoting the
fault message.
Problem solving guide
59