Filter
Top Products
With the aid of the following explanatory
notes, minor faults can be corrected
without contacting the Miele Service
Dept.
Any work on the electrical components
of the machine should only be carried
out by a suitably qualified and
competent person in accordance with
local and national safety regulations.
Unauthorised repairs could be
dangerous.
Faults / possible causes
The machine does not start
– The door is not properly closed.
– The machine is not switched on at
the mains.
– The fuse is defective / has blown.
A few minutes after switching on, the
p / 6 indicator light flashes (fault
code F..E appears in the display)
–
The stopcocks are closed.
–
The filters in the water inlet hose are
dirty.
–
The water pressure is too low.
^
Turn the programme selector to the
STOP position f (the fault code
goes out).
^
Press I-0 to switch the machine off.
^
Open the stopcocks or clean the
filters (see "Cleaning and Care").
^
Switch the machine on again and
reselect the programme.
The wash cycle finishes too early and
the p / 6 indicator light flashes
(fault code F A appears in the
display)
–
The drain hose is kinked.
–
The drain pump is blocked
^
Turn the programme selector to the
STOP position f (the fault code goes
out).
^
Straighten the hose and check/clean
the drain pump.
^
Pump away the water and start the
programme again (see additional
programme "DRAIN" and "Switching
on").
Correcting minor faults
44