Filter
Top Products
,
All electrical work must be
carried out by a suitably qualified
and competent person in
accordance with local and national
safety regulations.
^
Connection should be made via a
suitable isolator, with an on-off switch
which should be easily accessible for
servicing work.
WARNING
THIS APPLIANCE MUST BE
EARTHED
^ For extra safety it is advisable to
install a residual current device with a
trip current of 30 mA (in accordance
with DIN VDE 0664).
^ The mains connection cable may
only be replaced by an original Miele
spare part or an apppropriate cable
with wire end ferrule
.
^ For technical data see data plate or
wiring diagram supplied.
The machine must only be operated
with the voltage, frequency and fusing
shown on the data plate
.
This machine can be converted in
accordance with the conversion
diagram and wiring diagram supplied.
The data plate
(with test certification
VDE, DVGW etc.) and conversion key
are located on the rear of the machine
and also behind the plinth panel below
the protective plastic cover.
The wiring diagram
is secured to the
inner side of the protective plastic
cover.
Removing the plinth panel and the
protective plastic cover:
,
Disconnect the machine from the
mains electricity supply.
^ Holding the plinth panel at both
sides, pull gently outwards from
beneath a and pull it off b.
^ To remove the protective plastic
cover loosen the 2 screws (left and
right) c.
To re-assemble:
^
Refit the protective plastic cover and
the plinth panel in the reverse order
to which they were removed.
See also the installation diagram
supplied.
Bonding connection
There is a screw connection point
marked with the earth symbol (
8) at
the back of the machine, to which the
earth lead must be connected.
Electrical connection
48