Filter
Top Products
^
Remove the securing device g.
^
Place the panel b onto the soft-close
mechanism from above, engaging it
at the bottom first and then at the top.
^ Close the top door of the appliance.
Remounting the door handles:
The following instructions must be
followed when attaching the door
handle, otherwise the door seal
could be damaged.
^
First, loosely screw the door handle
onto the opposite side with the two
front screws b.
The mounting plate c must be
positioned on the door housing in such
a way that when the door is closed the
mounting plate is aligned with the
outside wall of the appliance.
If this alignment is off, you can correct it
by
^
turning both of the pre-mounted set
screws a with a wrench until the
mounting plate c is at the correct
angle.
^
Tighten all 4 screws b.
^
From the appliance side, slide the
sidebar d onto the guide for the
mounting plate, until it audibly
engages.
Make sure that the sidebar d does
not come in contact with the door
seal when the door is opened. This
would damage the door seal over
time.
If you see that the sidebar is coming
into contact with the door seal,
^
adjust the mounting plate c again
using the set screws a until the
mounting plate and the sidebar d
are at the correct angle and the
sidebar no longer touches the seal
when the door is opened.
Changing the door hinging
58