Filter
Top Products
Cleaning the ice cube tray
The ice cubes are formed in a tray
before they are dropped into the
drawer.
The tray should be cleaned regularly to
remove any stale ice or water.
^
Connect the appliance to the
electrical supply.
^
Press the On/Off button for the ice
cube maker, the indicator light will
turn on.
^
Empty the ice cube drawer.
^ Press the On/Off button for the ice
cube maker for approx. 10 seconds
(after approx. 1 second the ice maker
will turn off and the indicator light will
go out).
The indicator light will flash.
^ Push the ice cube drawer in as far as
it will go within the next 60 seconds.
The ice cube tray will then rotate into an
angled position for easier cleaning.
Wait until the ice cube tray has
completed this rotation before
continuing.
^
Remove the ice cube drawer.
^
Clean the ice cube drawer and tray
with a mild solution of warm water
and liquid dish soap.
^
Press the On/Off button on the ice
cube maker.
The ice cube tray rotates back into its
original position.
^
Replace the ice cube drawer and
close.
The ice cube maker will begin
producing ice cubes again after a
maximum of 6 hours.
If the ice cube maker has not been
used for an extended period of time,
it is important to clean the ice cube
tray before using it again.
Ventilation slits
^ Check the ventilation slits regularly.
Remove any dirt/dust with a vacuum
cleaner or brush. Clean as needed.
Cleaning and Care
28