Filter
Top Products
Ventilation
The air at the rear wall of the appliance
gets warm. Therefore sufficient space
must be provided around the appliance
for ventilation.
A ventilation gap of at least 1 1/2"
(38 mm) must be provided behind the
appliance.
The air intake to the appliance is made
through the base of the installation
niche. The ventilation cross-section
must be at least 78 3/4"
2
(200 cm
2
)to
ensure that the warm air can escape
without obstruction.
The air intake and outlet must not be
blocked or covered in any way. They
also need to be dusted/cleaned on a
regular basis.
Before installation
^
Remove the cover strip, the sealing
strip and other accessories from the
inside and from the exterior rear wall
of the appliance.
^
Do not remove the spacers from the
rear wall of the appliance. They
ensure that there is enough space
between the rear wall of the
appliance and the wall.
^ Remove the cable clips from the rear
of the appliance.
^ Check that all the parts on the rear
the appliance can move freely. Bend
any parts carefully if needed.
Did the old appliance have a
different hinge system?
Even if your old appliance had a
different hinge system you can still use
a custom door panel.
^
Un-install the old hinges; they are no
longer necessary, the custom door
panel will be mounted on the
appliance door.
All necessary parts are included with
the appliance or can be ordered from
Miele.
Installation
43