Filter
Top Products
Programming the end of
cooking time
The duration and end of a programme
can be pre-programmed. This applies
to all functions your appliance offers.
^
Proceed as for starting a programme.
^
However, at the end press the m
button instead of the START button.
The time of day will flash in the
display.
^
Use the rotary selector to enter the
time you wish the programme to
finish. The h symbol will flash and
the end time, the symbols for the
function selected and r to show
that an end of cooking time has been
set will light up in the display.
^ Press START.
r and the time of day will light up in
the display.
The appliance will switch on
automatically and then off at the
selected end of cooking time.
If the end of cooking time is
programmed for microwave
operation make sure that there is
food in the oven.
To check the end of cooking time
It is possible to check the end of
cooking time before a programme has
started.
^
Press the m button. The selected
method of operation and the
pre-selected end time will appear.
Large cooking dishes
If the dish is larger than the turntable it
might not turn around in the oven. If this
is the case the turntable must be
switched off.
^ Press the ä button.
If the door is opened before a
starting time has commenced
^ press the START button again after
closing the door. The appliance will
then start at the pre-selected time.
To change programmed times
^
Press the Stop/C button and
programme the times in again.
To delete programmed times
^
Press the Stop/C button.
Operation
28