Filter
Top Products
Buzzer
A buzzer sounds at the end of the
programme or if there is a fault.
You will hear the buzzer at the end of a
programme. It will sound four times in
intervals with a noticeable pause in
between.
In the event of a fault, the buzzer will
sound four times in intervals with only a
very short pause in between.
The buzzer is activated as standard at
the factory.
You can deactivate the buzzer at the
end of a programme if you wish. The
buzzer which sounds when there is
fault cannot be deactivated.
^ Open the door.
^ Switch the dishwasher off using the
On/Off button K.
^ Press the programme selector button
X in, and whilst holding it in switch
the dishwasher on using the On/Off
button K.
Keep the programme selector button
X pressed in until the lower right
hand programme indicator comes
on.
If this does not happen, start the
procedure again from the beginning.
^
Press the Turbo button 4 times.
The Turbo indicator will flash briefly four
times at intervals.
The flashing sequence in the display
shows what the current setting is.
–
"p1": The buzzer is activated
–
"p0": The buzzer is deactivated
^
If you want to change the setting,
press the programme selector button
X.
The setting is now stored in memory.
^ Switch the dishwasher off using the
On/Off button K.
Additional functions
44