Filter
Top Products
Factory default
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^
Open the door.
^
Switch the dishwasher off using the
On/Off button K.
^
Press the programme selector button
X in, and whilst holding it in switch
the dishwasher on using the On/Off
button K.
Keep the programme selector button
X pressed in until the lower right
hand programme indicator comes
on.
If this does not happen, start the
procedure again from the beginning.
^ Press the Turbo button twelve times.
The Turbo indicator light will give one
long flash and two brief flashes at
intervals.
The flashing sequence in the display
shows what the current setting is.
–
"p1": All settings are set to factory
default settings.
–
"p0": At least one setting has been
changed.
^
To reset to the factory default
settings, press the programme
selector button X.
The setting is now stored in memory.
^
Switch the dishwasher off using the
On/Off button K.
Additional functions
48