Filter
Top Products
Water inlet/drain fault
Problem Possible cause Remedy
The dishwasher
stops working
shortly after the
start of the
programme.
The buzzer sounds.
The Inlet/drain
check light 2/2
flashes when the
door is opened.
The stopcock is
closed.
–
Open the stopcock fully.
The dishwasher
stops during a
programme.
The buzzer sounds.
The Inlet/Drain
check light 2/2
flashes when the
door is opened.
Fault code FXX
shows in the
display.
Before rectifying the problem:
– Switch the dishwasher off using the
On/Off button K.
Fault F12/F13:
Water intake is
restricted.
– Open the stopcock fully.
– Clean the water inlet filter (see
"Maintenance").
– The water pressure at the intake is
lower than 30 kPa (0.3 bar).
Seek professional advice.
Fault F11:
Water outlet is
restricted, water
remains in the
wash cabinet at
the end of a
programme.
– Clean the filter combination. See
"Cleaning and care".
–
Clean the drain pump. See
"Maintenance".
–
Clean the non-return valve. See
"Maintenance".
–
Remove any kink in the drain hose.
Problem solving guide
56