Filter
Top Products
Optimise standby
To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or a few minutes after the end
of the programme. The indicator lights
and the time display will go out and
only the On/Off indictator light K will
flash slowly.
If the dishwasher is not switched off at
the end of the programme, it will switch
off completely after a few minutes in
Standby mode.
The Optimise standby function can be
deactivated if wished. The display and
the indicator lights will not go out, and
the time lapse before the dishwasher
switches off will increase to approx. 6
hours, resulting in higher energy
consumption.
The dishwasher will not switch into
Standby mode whilst a programme
is running, if salt or rinse aid needs
to be replenished or there is a fault.
^
Open the door.
^
Switch the dishwasher off using the
On/Off button K.
^
Press the programme selector button
X in, and whilst holding it in switch
the dishwasher on using the On/Off
button K.
Keep the programme selector button
X pressed in until the lower right
hand programme indicator comes
on.
If this does not happen, start the
procedure again from the beginning.
^ Press the Turbo button eight times.
The Turbo indicator will flash briefly
eight times at intervals.
The flashing sequence in the display
shows what the current setting is.
–"p1": Optimise standby is activated.
–"p0": Optimise standby is
deactivated.
^
If you want to change the setting,
press the programme selector button
X.
The setting is now stored in memory.
^
Switch the dishwasher off using the
On/Off button K.
Additional functions
47