26
Cleaning the top oven roof
The grill element is hinged to make cleaning the
oven roof easier.
WARNING!
Switch off the appliance from the electricity
supply before cleaning and ensure the oven
is cold.
1. Remove the wirework side runners.
2. Undo the two screws, which hold the grill
element in place.
3. Gently pull the element downwards to allow
access to the oven roof. Do not force the
element downwards.
4. Clean the top of the oven with cream cleaner
and a sponge scourer. If heavily soiled,
aerosol oven cleaners may be used following
the instructions for cleaning the grill / top
oven compartment.
5. Gently push the grill element back into place.
6. Fit the screws to hold the element in place
and tighten firmly.
7. Replace the wirework side runners.
WARNING!
Ensure the screws are firmly in place after
cleaning.
WARNING!
Aerosol cleaners must not come into contact
with elements/burners, door seal, or any
painted finishes as this may cause damage.
Cleaning the door(s)
WARNING!
To prevent damaging or weakening the door
glass panels avoid the use of the following:
•
Household detergents and bleaches
•
Impregnated pads unsuitable for non-
stick saucepans.
•
Abrasive cleaning pads, scourers and
steel wool pads.
•
Chemical oven pads or aerosols.
•
Rust removers.
•
Bath/Sink stain removers.
IMPORTANT!
The outer door glass is removable for cleaning.
To remove the outer door glass
1. Open the oven door slightly to gain access to
the two cross head screws on the top of the
oven door.
2. Loosen the two screws using a Pozidrive
screwdriver.
3. Hold the door glass securely in place with
one hand before removing the screws and
washers completely with the other hand. The
screws and washers retain the trim on the
top of the grill door. Note the position of the
trim on the door.