Filter
Top Products
34
Installation instructions continued
How to finish unpacking
•
Place packed appliance next to the space
in which it will be installed.
•
Remove the appliance packing except for
bottom tray, which should be left in position
until the appliance is ready to be fitted into
its cabinet.
IMPORTANT!
It is imperative that the appliance is left in the
base to protect both the appliance and the floor.
•
Ensure the user is given these operating
instructions.
IMPORTANT!
Important: Switch off at the mains, miniature
circuit breaker and if appropriate, remove fuse
before commencing any electrical work.
To remove the mains
terminal cover
•
From the rear of the appliance, remove
mains input terminal cover to gain access to
terminal block.
•
First remove retaining screw with pozidrive
screwdriver.
•
Prise cover loose using screwdriver in
position (1) then lever off with screwdriver in
position (2) at either side.
•
Lift cover and remove screw from cable
clamp.
Connecting to the mains
terminal
WARNING!
This appliance must be earthed.
•
We recommend you use a new length of
6mm2 twin core and earthed cable to ensure
your safety.
•
Make connection as shown below by
proceeding as follows: -
•
Pre-form wires to the appropriate shape to
suit fitting into the mains terminal block.
•
Strip inner insulation on wires using wire
strippers.