Filter
Top Products
31
Installation instructions
WARNING!
•
This appliance must be installed by a
qualified electrician/competent person.
Safety may be impaired if installation is
not carried out in accordance with these
instructions.
•
This appliance must be earthed.
•
Do not remove the screws from the earth
tab extending from the oven mains
terminal block
•
Before connecting the appliance make
sure that the voltage of your electricity
supply is the same as that indicated on
the rating plate. T
his is usually situated on
the front frame of the appliance and can be
seen upon opening either the main or top
oven door. Alternatively the rating plate
may also be found on the back or top of
some models (where applicable).
•
Do not alter the electrical circuitry of this
appliance.
Things to note
•
This appliance is designed to be fitted in
cabinets of the recommended dimensions as
shown (Recommended cabinet dimensions).
•
If your cabinet interior dimension is between
565- 570mm the oven may still be fitted.
However, a minor modification to the cabinet
will be required to reduce the aperture size
down to 560-565 mm, to allow the product to
be securely screwed into the cabinet.
•
The dimensions given provide adequate air
circulation around the unit within the cabinet,
ensuring compliance with BS EN60-335.
•
Enquiries regarding the installation of the
cooker point, if required, should be made to
your Regional Electricity Company to ensure
compliance with their regulations.
•
The appliance socket switch should be
outside the cabinet but within 2m of the
appliance to make it accessible to switch off
the appliance in case of an emergency.
•
To protect the hands, wear gloves when
lifting the oven into its housing.
WARNING!
Do not lift the appliance by the handles.
IMPORTANT!
House circuit
Earth leakage and continuity tests must be
carried out before the appliance is connected to
the mains supply and re-checked after fitting.