Filter
Top Products
19
How to Operate your Dishwasher • MD-1000HT
1. Make sure there is adequate supply of liquid detergent and rinse-aid.
Check the chemical containers and refill if necessary.
2. Ensure internal circular tank screen, upper and lower spray arms and lower external
scrap screen are clean and in place.
3. Close door. Turn POWER switch to the “ ON ” position. Lift “FILL/DRAIN” switch to the “FILL”
position and hold for approximately 15-20 seconds, or until water flows from the wash tank
into the lower scrap pan.
4. Check the wash temperature gauge. Minimum reading must be 150°F/66°C.
Operate the dishwasher through 2 complete cycles to increase the wash temperature to
150°F/66°C. Check the temperature gauge reading on the front of the dishwasher to ensure
minimum temperatures are maintained.
5. Open doors completely and slide pre-scrapped rack of dishes into dishwasher.
Check that control panel green light is out.
6. Close doors to automatically start the cycle. Total cycle time is 90-seconds.
7. The RINSE SENTRY feature monitors the final rinse water temperature being generated in
the built-in booster. The rinse sentry will extend the wash cycle in the event that the
final rinse temperature is less than 180°F/82°C. Rinse Sentry deactivates when the final rinse
water in the built-in booster is a minimum of 180°F/82°C. Then the dishwasher timed cycle will
complete the wash cycle, drain and refill with the final rinse water and complete the cycle.
(See page 20 for an in-depth explanation of the Rinse Sentry feature.)
8. The final rinse cycle begins after the dishwasher washes and then drains.
The rinse-aid is automatically added to the wash tank.
9
. Cycle ends when green cycle light goes out. Opening the doors anytime during the
timed cycle will stop the dishwasher. The dishwasher will resume operation as soon as
the doors are closed. The timed cycle will begin at the place where it had stopped.
9. Open door. Remove the clean rack of dishes and insert another rack of soiled dishes.
10. Repeat steps 5-12 until all wares are clean.
Note:
Wash temperature must be a minimum of 150
o
F/66
o
C for optimum wash performance.
Pumped final rinse temperature must be a minimum 180-195
o
F/82-91
o
C for sanitizing.
________________________Installation Guide
; How to Operate your Dishwasher MD-1000HT