Filter
Top Products
41
PROBLEM CAUSE SOLUTION
Low final rinse temperature Low incoming water ................... Check valve to be sure it is clean and
..................................................... operating.
Defective thermometer ............... Check for proper setting or replace
Machine leaking Leaking at chemical hose .......... Replace hoses
Pump seal leaking...................... Replace seal
Leaking at pump hose ............... Contact your chemical supplier
Leaking at doors ......................... Check to make sure that doors are fully closed
Water splashing out door Nozzles/End caps missing ........ Replace caps
Wash nozzles blocked ................ Clean
Arms not rotating......................... Replace bearings
Door handle twisted
(pass through) ............................ Adjust or replace handle
Poor washing results Detergent dispenser not
operating properly ....................... Contact detergent supplier
Insufficient detergents ................ Contact detergent supplier
Food Soil concentration too
high in wash tank ........................ Prescrap dishes throughly
Wash water temperature
too low ......................................... See condition “Wash Tank
Water Temperature” above
Wash arm clogged ..................... Clean
Improperly scraped dishes ........ Check scraping procedures
Ware improperly
placed in rack .............................. Use proper racks. Do not overload racks
Improperly cleaned
equipment ................................... Unclog wash sprays and rinse nozzles
to maintain proper pressure and flow
conditions. Overflows must be open.
Keep wash water as clean as possible.
The Troubleshooter • MD-1000LT
The Troubleshooter (continued)