Filter
Top Products
37
How to Clean your Dishwasher • MD-1000LT
1. Leave the machine power switch in the ON position. Doors are fully closed.
2. Push and hold the “FILL/DRAIN” switch down in the “DRAIN” position for approximately
15-20 seconds. The water in the wash tank will drain completely.
3. Raise doors fully. Use caution, as metal surfaces may be hot. Allow interior to cool.
4. Rinse the interior of the dishwasher with fresh water. Wipe the interior with a soft cloth.
Do not scrub the interior with scouring pads, nor harsh detergents.
5. Close the doors fully; the dishwasher will begin a normal cycle. At the end of the cycle,
Push & hold the Fill/drain switch in the DRAIN position until the wash tank is empty
6
. Flip the dishwasher power switch to the OFF position
7. Remove and clean circular wash tank screen.
8. Check the overflow /drain assembly. Ensure the drain seat is clean.
9. Loosen the upper and lower thumbscrews (Do not remove the screws)
Remove upper and lower sprayarms. Flush the sprayarm nozzles and check the
bearing o-rings.
10. Replace sprayarms (they are interchangeable) and tighten thumbscrews.
11. Replace circular tank screen.
12. Remove lower scrap screen. Empty debris and flush both sides with fresh water.
13. Check the drain pan and flush with clean water.
14. Wipe the exterior of the dishwasher with a soft cloth.
Do not hose the exterior with water nor scrub with scouring pads or harsh detergents.
15. Replace lower scrap screen, circular screen, and leave doors open for overnight drying.
1
6. Check the chemical supplies to ensure there are adequate supplies for the next shift.
________________________________ Installation Guide
; How to Clean the MD-1000LT