Filter
Top Products
20
The MD-1000HT Rinse Sentry automatically monitors the final rinse water temperature in the
built-in stainless steel electric booster heater. If the final rinse water in the booster falls below
180°F/82°C, the Rinse Sentry will extend the dishwasher's wash cyle time in order to give
the booster heater additional time to provide the 180°F/82°C water temperature required.
Sanitization using hot final rinse water:
1. The MD-1000HT sanitizes dishware with a pumped hot final rinse water at a minimum
temperature of 180°F/82°C.
2. The MD-1000HT includes a built-in stainless steel electric booster heater which heats
incoming water temperatures to 180-195°F/82-91°C.
3. With Rinse Sentry, if the final rinse temperature inside the booster tank is below the
minimum 180°F/82°C, the timed cycle pauses the wash cycle until the minimum
temperature is available.
4. If something is defective and the final rinse water cannot reach the 180°F/82°C,
then the dishwasher will wash indefinitely.
5. This is usually the point where the operator realizes that the dishwasher has a
problem because the wash cycles are way too long.
Who is responsible for checking the final rinse water temperature?
1. The people operating the dishwasher, that's whom?
2. You are required to check to make sure that the final rinse water temperature gauge
always reads a temperature of 180-195°F/82-91°C during the final rinse cycle. And, It is
your job to immediately stop washing dishes if the temperature falls below the minimum
temperature of 180°F/82°C.
3. Guess what? Most people will forget to check the final rinse temperature at least once
in their careers! That's why the RInse Sentry is a part of your dishwasher.
Installation Guide _____________
; What is the Rinse Sentry Feature? MD-1000HT
MD-1000HT • What is the Rinse Sentry Feature?
Rinse Sentry constantly checks the final rinse water temperature
to ensure the minimum required temperature of 180°F/82°C is available
to sanitize the dishware for the health and safety of your guests.