Pitco Frialator SELV14T Fryer User Manual


 
INSTALLATION & OPERATIONAL SELV MANUAL
19 L20-406 Rev 5 (3/14)
0
1
4.10.3 Hold Time
Cooked product may stand in holding bins for a period of time. This timer produces an alarm to
inform operators to discard old product and start a new cook. Default for this
value is zero, meaning the Hold Time is inactive.
Display is showing [nHD mm:ss] [TIME], where “n” is the key number, “HD
means HOLD, and “mm:ss” is minutes and seconds.
Use the product keys for numeric entry to adjust the current setting. Press the [Clock] key to save
hold time and continue setup for this product key.
4.10.4 Hold Pre-Alarm
Hold Pre-Alarm is a timer setting that is used to warn operators that the Hold Time is about to
expire. To use Hold Pre-Alarm, time value must be a non-zero value, and must be set to a value
less than Hold Time. Default value is zero, meaning the Hold Pre-Alarm is inactive.
Display is showing [nPA mm:ss] [TIME] where “n” is the key number, PA means Pre-Alarm, and
“mm:ss” is minutes and seconds.
Use the product keys for numeric entry to adjust the current setting.
Press the [Clock] key to save cook time and continue setup for this product key.
Note: Value entered for Hold pre-alarm time is the hold time minus the pre-alarm
time. Example: 15:00 hold time with a 5:00 prealarm time, the value you enter
would be 10:00 minutes.
Display will again return to [SELECT] [TIME]. Repeat steps from 1 to make changes to any other
product keys or continue.
4.11 ToExitLevel1programming:
Display shows [SELECT] [TIME]. Continue to make changes or exit here in next step.
Press the [P] key.
Display shows [PROGRAM].
To exit Level 1 programming, press the [P] key again.
Displays will show [HEATING], [MELT] [LIQUID (or SOLID)], or [READY].
4.12 ToEnterProgrammingLevel2(fortheStoreManager)
The display must show [PROGRAM] from (See section 4.8 “To Enter Programming
Level 1” (For the Store Manager). to change these options. When the product key [0]
is pressed, the display will show [SELECT] [OPTIONS]. Indicator lights above
product keys will illuminate to represent options that may be changed. Each option
listed below uses the product key [0] to toggle or scroll through available choices in
the display. When the correct value is displayed, press the [P] key to save choice. The display will
again return
to [PROGRAM] for another option selection.
4.13 FahrenheitorCelsiusDisplay:
The Controller will display temperatures in the Fahrenheit or Celsius scales. The default
scale is °F. With display showing [PROGRAM], press the product key [0].
Display shows [SELECT] [OPTIONS].
Press product key 1, display shows [DEGREE n] [F OR C], where “n” is the current
setting.
Use the product key [0] to scroll through choices (F or C). Press [P] key to save choice.
Display shows [PROGRAM].