Rangemaster 110 Range User Manual


 
15
To fi t the small inner burner, fi nd the larger
electrode notch in the burner rim. Line this up
with the white ignition electrode and place the
inner burner on the large base ring.
A electrode notch B ignition electrode
Now fi t the two trim rings, making sure that they
are sitting down properly.
Griddle
Always clean the griddle after use. Allow to
cool completely before removing. Immerse the
griddle plate in hot soapy water. Use a soft
cloth or, for stubborn stains, a nylon washing up
brush.
NEVER USE CAUSTIC OR ABRASIVE
CLEANERS AS THESE WILL DAMAGE THE
SURFACE.
Control Panel and Doors
The control panel and control knobs should
only be cleaned with a soft cloth wrung out
in clean hot soapy water - but take care that
no surplus water seeps into the appliance.
Wipe with a clean dampened cloth then polish
with a dry cloth. The oven doors should only be
cleaned with a soft cloth wrung out in clean hot
soapy water.
Cookers with window doors
On some models the oven door front panel can
be taken off so that the glass panels can be
cleaned. If the top edge of the oven door of your
cooker has a line of holes and there are screws
in the side edges then it can be taken apart for
cleaning.
Move the cooker forward to gain access to the
sides (see the ‘Moving the cooker’ section of
these instructions).
Open the oven door slightly and remove the
front panel fi xing screws from the door sides
(two each side).
some window doors only
Carefully lift off the outer door panel. The inside
face of the glass panels can now be cleaned
- take care not to disturb or wet the door
insulation. Please note that the door is triple
glazed but the inner two panels are fi xed and
should not be separated. After cleaning carefully
refi t the outer door panel and replace the side
xing screws.
Grill
The face of the grill burner will darken with
use - this is perfectly normal. Any fat or grease
will burn off. Do not try to clean it - the small
holes could get blocked and affect burner
performance.
The grill pan and grid should be washed in hot
soapy water. After grilling meats or any foods
that soil, leave to soak for a few minutes in the
sink immediately after use. Stubborn particles
may be removed from the grid by using a nylon
brush.
Oven
Cleaning is easier if carried out while the oven is
still warm. Before cleaning, cover the burner to
prevent the burner holes becoming blocked.
The inside of the oven and inner door panel can
be cleaned using an approved cleaner see the
table at the end of this section.
Take care not to disturb the oven thermostat
temperature sensor at the top of the oven
opening.
The enamelled oven burner trim (supplied with
some models only) can be removed for cleaning.