Filter
Top Products
33
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
23. To Change Oven Door Latch
Remove outer door panel (see 22). Remove screws
‘B’ holding latch assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
24. To Adjust an Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fi t is
obtained. Retighten locking nut.
25. To Change Oven Door Seal
Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that hook is
released. Proceed to the next hook and release it in a
similar way, and so on. Use force if the hooks are stiff,
as the old seal will be discarded.
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes
of the door, and proceed round the door snapping in
each hook in turn.
26. To Change Warmer Neon
Remove RH hotplate (see 2). Carefully place hotplate
upside down on a suitable fl at surface. Remove 2
screws holding neon bracket to Warmer frame. Fit new
neon and bracket assembly.
Reassemble in reverse order and check for correct
operation.
27. To Change Warmer
Remove RH hotplate, see 2. Fit new RH hotplate and
reassemble in reverse order.
Check High burner and Warmer operation is
satisfactory.
28. To Change Ignition Generator
Disconnect from electricity supply.
Pull cooker forward to gain access to the cover
box at the rear of the cooker. Remove the screws
securing the cover and lift clear. Pull off all the leads
to the generator noting their positions. Slacken the
two screws holding generator to cooker and remove
generator.
Fit new generator to cooker and replace leads.
Reassemble in reverse order. Refer to wiring diagram.
Check ignition performance.
29. To change oven light bulb.
Disconnect from electricity supply.
Open the oven door and remove the Handyrack (if
fi tted) and oven shelves.
Unscrew the bulb cover by turning anticlockwise.
Unscrew the old bulb. Screw in the new bulb, screw
back the bulb cover. Turn on the electricity supply and
check that the bulb now lights.