Filter
Top Products
29
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Servicing Notes
When servicing or replacing gas carrying components
disconnect from gas before commencing operation
and check appliance is gas sound after completion.
When checking for gas leaks use a liquid leak detector
at all joints and connections to check for leaks in the
system. Use a product specifi cally manufactured for
leak detection. Leak testing of the appliance shall
be conducted in accordance to the manufacturer’s
instructions.
CAUTION: DO NOT USE A FLAME TO CHECK
FOR GAS LEAKS.
Do not use re-conditioned or unauthorised gas
controls.
Disconnect from electricity supply before commencing
servicing, particularly before removing any of the
following: control panel, side panels, cooktop tray,
or any of the electrical components or cover boxes.
Before electrical reconnection check that the appliance
is electrically safe.
1 To Remove the Control Panel
Disconnect from electricity supply.
Open the oven door & grill door and remove the fi xing
screws underneath the control panel. The screws
directly below the clock are for the clock fi xing bracket
- don’t remove them at this stage. Some models have
a plate under the control panel held in place by the
bottom fi xing screws.
Remove the handrail by removing the 2 end bracket
fi xing screws.
Remove the 2 cross-headed screws that were hidden
by the handrail end brackets.
Pull off all the control knobs.
Lift the control panel, pull forward.
Disconnect the wiring from the rear. Reassemble in
reverse order. When replacing leads refer to the wiring
diagram. Check operation of timer.
2. To Remove Hotplate Trays
Disconnect from electricity supply.
Pull the cooker forward to gain access to the rear
Left hand tray
From the rear remove the screws securing
the fl ue grille to the hotplate tray. Remove
pan supports, burner heads and caps.
Remove the 4 screws and washers holding
the hotplate tray to the frame. Raise the front
of the hotplate then withdraw.
Right hand tray
From the rear remove the screws securing
the fl ue grille to the hotplate tray. If the LH
hotplate has not been removed, slacken the
screws holding the L H tray. Remove pan
support, burner head, caps and trim rings.
Remove the screws holding the Wok burner
to the hotplate. Remove the two screws and
washers holding the RH tray to the frame.
Press the Wok burner down slightly and,
taking care not to damage the Wok burner
electrode, slide the tray about 30mm to right
to clear the locating brackets on the R H
side. Lift tray slightly at the front and taking
care not to stress the Warmer/lead junction,
disconnect the leads to the Warmer neon
and separate the leads at the piggybacks.
Withdraw the hotplate.
Reassemble in reverse order ensuring that the leads
are reconnected. When replacing the RH hotplate take
care not to damage the ignition electrode of the Wok
burner.
It is important that the rear fi xing screws are refi tted as
they from part of the cooker earthing.
On some models there is a separate plate.
A fl ue grill, B cooker backsheet, C earthing/fi xing screws
On others it is a tag on the cooker backsheet.
It is important that the tag is on the outside and that
both fi xing screws are fi tted.
A fl ue grill, B cooker backsheet, C earthing/fi xing screws
Check for correct burner operation.