Filter
Top Products
31
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
11. To Change Hotplate Burner Electrode
Lift off pan supports, remove burner cap. Remove the
screw holding the electrode. Pull electrode vertically
up suffi ciently to grip the lead between thumb and
forefi nger. Pull off the electrode, but keep hold of the
lead. Fit new electrode to the lead. Fix electrode in
burner with screw. Replace burner cap. Check the
burner ignition. Replace pan supports.
12. To Remove or Change a Hotplate Burner.
Remove the hotplate tray (see 2).
LH hotplate burners
Remove heat shield (2 screws). The burners are
mounted in 2’s on cross supports. Disconnect the
burner feed pipes at the burners. Remove the screw
on the right holding the cross support. Slide the
support to the right to release in from the left hand
location. Lift the cross support and burners clear. The
burners are fi xed to the cross supports with 2 screws
Remove the appropriate burner and fi t the new one.
Reassemble in reverse order. Check burner operation
is satisfactory.
RH Wok burner
Disconnect the burner feed pipes at the burner. Fit
the new one and reassemble in reverse order. Check
burner operation is satisfactory.
13. To Change Grill Injector
Remove the hotplate control panel, see 2.
spring clip
grill injector holder
Lift up the spring clip retaining the grill injector holder
and slide the injector holder out of the burner venturi.
Remove grill jet from adaptor and fi t new jet (see table
below for correct jet). Put the injector holder back in
the burner venturi.
14. To Change Grill Burner
Remove grill injector see 13.
A grill electrode plate fi xing screw
B position of grill burner fi xing screws
C front shield fi xing screws
D grill venturi
Remove the 2 screws holding the front shield and
remove the shield. Turn the grill venturi clockwise to
clear the front cross-member, lift up and remove. For
models with ignition disconnect the electrode lead
and remove the screw holding the plate around the
grill electrode. Support the grill burner from below and
remove the two screws (under the foil wrap) securing
grill burner the top of grill chamber. Remove grill
burner.
Reassemble in reverse order taking care not to
damage the grill electrode (where fi tted).
15. To Change Grill Electrode
Remove the grill burner see 14. Withdraw electrode
and pull off electrode lead. Fit lead to new electrode.
Reassemble in reverse order and check ignition is
satisfactory.