Rangemaster 110 Range User Manual


 
7
The Ovens
The clock must be set to the time of day before
the ovens will work. See ‘The Clock’ section of
these instructions for how to set the clock.
Before using for the fi rst time, to dispel
manufacturing odours turn the ovens to
Mark 7 and run for an hour. To clear the
smell make sure the room is well ventilated
to the outside air, by opening windows or
turning on a cooker hood for example. We
recommend that people with respiratory or
allergy problems should vacate the area for
this brief period.
1
Push in and turn the knob controlling the oven to
Gas Mark 9. The oven will light automatically.
2
Turn the control knob back to the Mark you wish to
cook on and for best results pre-heat for 15 minutes
before placing your dishes in the oven.
3
The ovens use our special ‘Heatfl ow’ system.
Because the oven burner is not hidden under the
oven base you will see the burner fl ames at the back
of the oven - this is perfectly normal.
The oven is protected by a safety cut off, which
reduces the supply of gas to the oven if the fl ames
go out, e.g. an interruption to the mains supply.
Initially the gas will burn with a small fl ame but after
approximately one minute the fl ame will become
larger indicating that the oven is full on.
4
Dishes cooking on the central shelf will cook at the
gas mark indicated on the knob.
5
Dishes placed above the central position will be
cooked at approx. one gas Mark higher, dishes
cooked below approx. one gas Mark lower. You can
therefore cook dishes requiring different gas Marks
at the same time.
6
The ‘S’ setting is a very low temperature for slow
cooking, overnight or while you are out or at work.
The ‘S’ setting can also be used for keeping food
warm.
The Clock
You can use the timer to turn the ovens on and
off. The clock must be set to the time of day
before the ovens will work.
To set the time of day
Press and hold as shown.
At the same time, press
(-) or (+) until the correct
time shows.
Don’t forget it’s a 24 hour
clock.
If you make a mistake or press the wrong button,
turn off the power supply for a minute or two and
start again.
If the key symbol
( ) appears on the left of the
display you have accidentally turned on the
key lock feature. See the section ‘Clock Special
Features’.