Filter
Top Products
17
To fi t the small inner burner, fi nd the larger electrode
notch in the burner rim. Line this up with the white
ignition electrode and place the inner burner on the
large base ring.
A electrode notch B ignition electrode
Now fi t the two burner caps, making sure that they
are sitting down properly.
Grill
The grill pan and grid should be washed in hot soapy
water. After grilling meats or any foods that soil, leave
to soak for a few minutes in the sink immediately
after use. Stubborn particles may be removed from
the grid by using a nylon brush. Alternatively the grill
pan can be washed in a dish washer.
To remove the grill pan support frame, pull the grill
pan forward.
Lift the grill pan clear of the support frame. The
support frame is held to the side rails by two clips on
each side.
For each side, support the side rail with one hand and
with the other hand lift the frame up and out of the
side clips.
For safety, push the side rails back into the grill
chamber.
The side rails can be removed to make cleaning the
grill chamber easer by unhooking them from the grill
chamber sides.
Slides can be wiped clean with soft cloth and mild
detergent.
Do not use any abrasive substance.
DO NOT put the side runners in a dishwasher
When you have fi nished, hook the side rails back onto
the sides of the chamber. To refi t the frame pull both
side rails forward and equal amount. For each side in
turn support the side rail and press the frame down
into the side rails. Replace the grill pan.
Control Panel and Doors
Avoid using any abrasive cleaners including cream
cleaners, e.g. Cif, on brushed Stainless Steel surfaces.
For best results use a liquid detergent e.g. Domestos
Multi Surface Cleaner.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean hot
soapy water. Wipe with a clean dampened cloth then
polish with a dry cloth. The oven doors should only
be cleaned with a soft cloth wrung out in clean hot
soapy water.