Filter
Top Products
26
INSTALLATION
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
Make 10 complete (360º) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the front
bottom corners of the cooker.
Unfold the rear edge of pack base tray. Open the grill door
and the Tall oven door. Grip under the control panel and
lift the front of the cooker.
Carefully push the cooker
backwards off the pack base.
Remove the pack base tray.
Position the cooker close to
its fi nal position leaving just
enough space to get behind
it.
Do not use the door handles or control knobs to
manoeuvre the cooker. Use the hotplate and griddle bowl
areas.
Conversion to LP
If the appliance is to be converted to LP gas do the
conversion at this point. See the conversion section of
these instructions.
Levelling
You are recommended to use a spirit level on a shelf in one
of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise to
lower.
When you are satisfi ed with the height and level raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the fl oor. Screw the
front roller adjuster anticlockwise to raise the front roller
so that the front of the cooker is supported on the feet,
not the front roller, to prevent accidental movement of the
cooker.
Leave the levelling tool on the adjuster with the handle of
the tool facing the rear of the cooker, so that the customer
can use it if they wish to move the cooker.
Replace the drawer by locating on side runners and push
in.
Fit the Handles
Remove the 4mm Allen screws from the doors with the
hexagon key tool. Use the screws to fi t the door handles.
The handles should be above the fi xings.
Remove the 4mm Allen screws from the top corners of the
fascia and fi x the front handrail in position.
Fitting the splash back (optional)
Remove the two fi xing screws (3mm hexagonal socket
head) and nuts that pass through the top of the rear fl ue
grille. Hold the splash back in position. From the rear refi t
the 2 fi xing screws and nuts.