Filter
Top Products
34
WARNING SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
10. To Change Hotplate Burner Injector
Remove burner cap and head. Remove old jet. Fit new
injector. Reassemble in reverse order. Check appliance is
gas sound.
11. To Change Hotplate Burner Electrode
Lift off pan supports, remove burner cap. Remove the
screw holding the electrode. Pull electrode vertically
up suffi ciently to grip the lead between thumb and
forefi nger. Pull off the electrode, but keep hold of the lead.
Fit new electrode to the lead. Fix electrode in burner with
screw. Replace burner cap. Check the burner ignition.
Replace pan supports.
12 To Remove or Change a Hotplate Burner.
Remove the hotplate tray (see 2).
The burners except the right hand wok burner are
mounted on support struts. For these burners, disconnect
the burner feed pipes at the burner. Remove the screws at
the front and rear holding the support struts. Lift the strut
and burners clear. The burners are fi xed to the support
struts with 2 screws. Remove the appropriate burner
and fi t the new one. Reassemble in reverse order. Check
burner operation is satisfactory.
RH Wok burner
Disconnect the burner feed pipes at the burner. Fit the
new one and reassemble in reverse order. Check burner
operation is satisfactory.
13. To Remove an Oven Door
Open the oven door. Loosen the two top hinge screws.
Support the weight of the door and remove the screw
nearest the hinge pin. Swing the hinge up and away from
the hinge pin on the door.
Lift the door away from the bottom hinge.
Re-assemble in reverse order.
When replacing the door ensure that the nylon hinge
bush is in position between the hinge pin and the hinge
bracket at the both the bottom and top.
14. To Change Main Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fi xing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove door handle from panel by unscrewing 2
retaining nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
15. To Change the Main Oven Door Latch
Remove outer door panel (see 14). Remove screws ‘B’
holding latch assembly to inner door panel. Fit new catch
and reassemble in reverse order.
Check correct door operation.
16. To Adjust the Main Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep, and
screw in or out as required until required fi t is obtained.
Retighten locking nut.
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small hooks
on the rear face. At the corner pull seal diagonally away
from the door centre until that hook is released. Proceed
to the next hook and release it in a similar way, and so
on. Use force if the hooks are stiff , as the old seal will be
discarded.
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of
the door, and proceed round the door snapping in each
hook in turn.