Roper 4347928 (333240-1) Cooktop User Manual


 
REMOVABLE OVEN DOOR
To remove:
1. Open the door to the stop position (see illustration).
2. Grasp the door at each side and lift up and off the
hinges.
See the cleaning chart on page 25.
NOTE: When the door is removed and hinge arms are at
stop position, do not bump or try to move the hinge
arms. The hinges could snap back causing an injury to
the hands or damage to the porcelain on the front of the
range. Cover the hinges with toweling or empty towel
. . . . . __ .
rorls while working in the oven area.
To replace:
1. Hold the door over the hinges with the slots at the
bottom edge of the door lined up with the hinges.
The hinge arms must still be in the stop position.
2. Slide the door down onto the hinges as far as it will
go and close the door.
STOP POSITION
REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when installing
or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pair of
rack guides.
2. Push the rack in until you reach the bump in the
rack guide, then lift the front of the rack a bit and
push the rack all the way in.
To remove:
1. Pull the oven rack out, then up, in one motion.
See the cleaning chart on page 25.
28
BUMP IN
RACK GUIDE