Filter
Top Products
10
* Suppose you want to set Programme Lock ON.
x 2
Procedure
1 Press the CUSTOM SETTING pad
twice within 2 seconds.
2 Enter 3, 2 for Programme Lock
ON.
3 Press the START pad to save the
setting.
4 Press the STOP/CLEAR pad to
exit from the Custom Setting
function.
NOTE : If you select Programme Lock OFF, the LOCK
indicator in the display will disappear when you press the
START pad.
Operation when Programme Lock ON is set
KEY
Operation
Custom Setting Title
When Programme
Lock ON is Set
1
Selecting Memory
Input Method
no operation
2
Selecting Auto Start
Operation
no operation
3
Programme Lock
Setting
operation
4
Audible Signal Sound
Volume Setting
no operation
5
Cooking Completion
Signal Setting
no operation
6 Memory Check operation
7
Counter Check/Clear check : operation
clear :
no operation
8
Air Intake Filter
Counter
check, clear :
operation
set : no operation
9
Selecting Operation
in Case of Magnetron
Failure
no operation
x2/x3
Multiplication Factors
for Double/Triple
Quantity
check : operation
set : no operation
EXPRESS
DEFROST
Express Defrost
Setting
check : operation
set : no operation
4. Audible Signal Sound Volume Setting
The volume of the audible signal can be adjusted to High,
Medium, or Mute.
CU41 : High = factory Setting
CU42 : Medium
CU43 : Mute
To Set Cooking Completion Signal Volume
Press the CUSTOM SETTING pad twice within 2 seconds then
enter the numbers
4, 1 for High
4, 2 for Medium
4, 3 for Mute
Press the START pad to save setting and the STOP/CLEAR
pad to exit from the Custom Setting function.
NOTE : Even when errors occur, your oven will not beep in
mute setting.
5. Cooking Completion Signal Setting
There is a choice of 4 different signals on your oven.
CU51 : 1 long beep = factory setting
CU52 : Repeating long beeps
CU53 : 4 short beeps
C 54 : Repeating short beeps
To Set the Signal Type
Press the CUSTOM SETTING pad twice within 2 seconds then
enter the numbers
5, 1 for 1 long beep
5, 2 for repeating long beeps
5, 3 for 4 short beeps
5, 4 for repeating short beeps
Press the START pad to save settings and the STOP/CLEAR
pad to exit from the Custom Setting function.
6. Memory Check
Use this setting to check the programming for a certain
memory.
* Suppose you want to know the information programmed
into memory 1, programmed for 4 minutes at 60% for
the 1st stage and 2 minutes at 30% at the 2nd stage
programmed Dual Digit Input.
3 2
Procedure Display
1 Press the CUSTOM SETTING
pad twice within 2 seconds and
enter 6.
x2
6
CHECKNO.
R-1900J [EN].indd Sec1:10R-1900J [EN].indd Sec1:10 4/28/09 10:01:26 AM4/28/09 10:01:26 AM
U