37
• <<PLACE TABLET IN PRE-GROUND
CHUTE >> – press “OK”
Place a cleaning tablet in the pre-ground
coffee receptacle, see figure 59. Then press
the “OK” button.
• <<PLEASE WAIT>>
The coffee brewing unit is positioned.
• <<WASTE CONTAINER UNDER POUR
SPOUT>> – press “OK”
Remove and empty the coffee waste
container. Place the emptied coffee waste
container under the coffee pour spouts, see
figure 60.
Note: The coffee waste container serves as a
collecting vessel for the cleaning fluid.
Then press the “OK” button and the cleaning
program starts.
Note: During the cleaning program the display
shows the following indications alternately:
• <<CLEANING CYCLE>>
The cleaning program carries out 6 cleaning
cycles. The pauses enable the cleaning
solution to take effect. The cleaning cycles
are counted off in the display.
• <<IN PROGRESS>>
The bar indication in the bottom line
increases with the advance of the pause
duration.
Note: In the event of a power failure or
interruption, the program must be restarted.
The cleaning process takes approximately 8
minutes. Then the following is shown on the
display:
• <<EMPTY WASTE CONTAINER>>
– Press “OK”
Empty and replace the coffee waste
container. Then press the “OK” button.
• <<REFILL WATER RESERVOIR>>
Remove the water reservoir, fill with water
and replace. Then press the “OK” button.
• <<CLEANING COMPLETED>>
When this message appears on the display
the cleaning program has finished.
Turn the bean hopper to the desired position.
The espresso machine is now ready for use
and in the status of the last selected coffee
mode.
Important: After running the cleaning program,
you are advised to throw away the first cup of
coffee from the espresso machine.
Running the cleaning program (continued)