Heading
Not enough froth when Frothing jug. For best texturing results use a
texturing the milk stainless steel jug and if possible
refrigerate or run the jug under
cold water before use.
During the texturing process Start again with fresh, chilled milk.
the milk has been over heated
and boiled.
The brewing unit The brewing unit is not in its Leave the machine switched on
cannot be removed normal position. and adjust the coffee bean hopper
to the pre-ground coffee position.
Then switch off the machine and
remove the brewing unit. See page
33, Removing the coffee brewing
unit.
The brewing unit Brewing unit is not closed Turn the white service lever
cannot be inserted correctly. upwards as far as it will go. The
ejection lever will fold back and the
brewing unit closes. See page 33,
Inserting the brewing unit.
The locking lever behind the Push the locking lever upwards and
service door is not in the up insert the brewing unit. See page
position. 33, Inserting the brewing unit.
PROBLEM POSSIBLE CAUSE WHAT TO DO
Trouble Shooting Guide continued
44