Taylor 028763- M Freezer User Manual


 
10
Model 220Important: To the Operator
Section 5 Important: To the Operator
Figure 1
ITEM DESCRIPTION
1 Control Switch (Switch- Rocker)
2 Dial Light (Light- Orange- Round)
3 Temperature Control (Control- Temp.)
Symbol Definitions
To better c ommunicate in the International arena, the
words on many of our operator s witches and buttons
have symbols to indicate their functions. Your Taylor
equipment is designed with these International
symbols.
The following chart i dentifies the symbol definitions
used on the operator switches.
=COLDER
=WARMER
= TEMP (Temperature)
Control Switch
When the control switch is placed in the “AUTO”
position, the refrigeration system will operate. When
the switch is placed in the “EJECT” position, only the
beater motor will operate.
Note: Never empty the contents of the
freezing cylinder while the control switch is in the
“AUTO” position. Always put the control switch into
the “EJECT” position when drawing product from the
freezing c ylinder. As an additional safety feature, this
unit will not operate i f the door is open.
Dial Light
Located to the right of the control switch is a round dial
light. When the control switch is in the “AUTO”
position, this light will come on, indicating the
refrigeration system is operating.
Temperature Control
Located on the right front side is the temperature
control knob. Turning the adjusting knob clockwise
will decrease product temperature. T urning the
adjusting knob counterclockwise will increase
product temperature. Each quarterturn will vary the
temperature approximately t wo degrees.
Reset Mechanism
Located on the left side panel is the reset button. The
reset protects the beater motor from an overload
condition. Should an overload occur, the reset
mechanism will trip. To properly reset the freezer,
place the control switch in the “OFF” position. Press
the reset button firmly. Place the control switch in the
“EJECT” position and observe the freezer’s
performance. Return thecontrol switch to the“AUTO”
position.