Filter
Top Products
13
Model 220 Operating Procedures
Slide the o- ring into the groove o n the bearing holder,
and lubricate.
Figure 9
Lightly lubricate the draw rod, and slide the bearing
holder onto the rod, locking stem first.
Figure 10
Thread the valve piston on the endof thedraw rod until
tight.
Figure 11
Lightly lubricate the inside of the valve body in the
freezer door.
Figure 12
Insertthedrawrodassembly,valvepistonfirst, intothe
valve body.
Figure 13
T urnthe drawrod handleto lock the bearing holderinto
place.
Figure 14