Taylor 028763- M Freezer User Manual


 
24
Model 220Troubleshooting Guide
Section 8 Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
1. Unit will not run in the
“AUTO” position.
a. Unit is unplugged. a. Plug in wall receptacle. --
b. Circuit breaker is off. b. Turn the breaker on. --
c. Unit is off on reset. c. Place c ontrol s witch in the
“OFF” position. Press
reset button firmly. Place
control s witch in the
“EJECT” position and
observe freezer’s
performance. Resume
normal operation.
10
2. Product is not freezing. a. Dirty condensers. a. Clean condensers
regularly.
22
b. The c ontrol s witch is not in
the “AUTO” position.
b. Place the control switch in
the “AUTO” position.
18
c. On water cooled units,
inadequate water supply.
c. Check to be sure the
water is turned on. Check
hoses for leaks or kinks.
22
3. Drive shaft is stuck. a. Rounded corners on shaft,
drive socket, or both.
a. Replace the drive shaft,
drive socket, or bot h. Do
not lubricate the hex end
of the drive s haft. Contact
a service technician.
--
4. Walls of freezer cylinder
are scored.
a. Scraper blades were
improperly ins talled.
a. Install them properly. 12
5. Excessive mix leakage in
the rear drip tray.
a. Drive s haft seal is worn or
missing.
a. Install or replace the seal. 11
b. Inadequate lubrication o f
drive shaft seal.
b. Lubricate properly. 11
c. Rear shell bearing is worn. c . Contact a service
technician.
--
d. The wrong type of
lubricant is being used.
d. Use Taylor Lube. --
6. Buzzer does not sound
when the freezer cycles
off.
(Note: the buzzer is an
optional feature.)
a. Buzzer is malfunctioning. a. Contact a service
technician.
--