Filter
Top Products
12
Model 220Operating Procedures
Step 2
Install the beater assembly. First check the scraper
blades for any nicks or signs of wear. If the blades are
in good c ondition, place the rear scraper blade into the
grooves on the beater (knife edge to the outside). The
pins on the b lades fit under the p ins o n the beater to
prevent the blades from falling off.
Figure 4
Holding t he rear blade on the beater, slide the beater
assembly into the freezing cylinder over the driveshaft
until the entire blade is inside. Install the middle
scraper blade into the two middle holding pins. Slide
the beater assembly in farther and install the front
scraper blade into the two front holding pins. Slide the
beater assembly the rest of t he way into the freezing
cylinder.
Figure 5
Make sure the beater assembly is pushed all the way
to the rear of the freezing cylinder and that the end of
the beater shaft p rotrudes from the end of the beater
assembly. When in position, the beater will not
protrude bey ond the front of the freezing cylinder .
Step 3
Assemble the freezer door. Insert the large o- ring
into the groove on the back of the freezer door.
Figure 6
Insert thefront bearing i ntothehole inthe center onthe
back of the freezer door.
Figure 7
Slide the o- ring into the groove on the valve piston,
and lubricate.
Figure 8