Filter
Top Products
14
Model 220Operating Procedures
T urn the bearing holder so the holes are aligned with
the holesin the valve body.Secure withthe keeper pin.
Figure 15
Step 4
Installthefreezerdoor.Alignthehole in the cross bar
with the hole i n either hinge, and insert the hinge pin.
The cross bar can be assembled for either right or left
opening. Holding the freezer door firmly, position the
door onto the cross bar . Align the cross bar with the
opposite hinge and insert the remaining hinge pin.
Figure 16
Make sure the freezer door fits securely over the
freezing cylinder. With the door seated over the front
of the freezing cylinder, install the cross bar screw
assembly in the center of the freezer door through the
cross bar. Tighten securely.
Figure 17
Step 5
Align the holes in the cover cap assembly with the
holes on the freezer door. Secure with the keeper pin.
Figure 18
Step 6
Slide the rear drip tray into the hole in the left side
panel.
Figure 19