Filter
Top Products
20
Model 428Operat ing Procedures
Step G -- Sel f--Clo sing Door Assembly
Place the o--ring onto the prime plug and lubricate.
Figure 28
Step H -- Self--Closi ng Door Assembly
Screw the prime plug into position on the fr ont of the
door.
Figure 29
Step I -- Sel f--Clo sing Door Assembly
Place the large rubber gasket into the groove on the
back side of the freezer door.
Figure 30
Step J -- Self--Closi ng Door Assembly
Slide the white, plastic front bearing onto the bearing
hub, making certain that the flanged end of the
bearing is resting against the fr eezer door . DO NOT
lubricate the door gasket o r front bearing.
Figure 31
Step K -- Self--Closi ng Door Assembly
Position the fr eezer door onto the four studs on the
front of the freezing cylinder and push the door into
place. Install the four handscrews onto the studs
and tighten them equally in a crisscross pattern to
insure that the door is snug. DO NOT over--tighten
the handscrews.
Note: If the freezer door does not fit into place
easily, position the open end of the beater assembly
in the 11 o'clock position.
Figure 32