Filter
Top Products
4
Model 428To the O perator
110121
Section 2 To the Operator
The freezer you have purchased has been carefully
engineered and manufactured to give you
dependable operat ion. The Taylor Model 428, when
properly operated and cared for, will produce a
consist ent quality product . Like all mechanical
products , they will require cleaning and
maintenance. A minimum amount of care and
attention is necessary if the operat ing procedures
outlined in this manual are followed closely.
This Operator’s Manual should be read before
operating or performing any maintenanc e on your
equipment.
Your Taylor fr eezer will NOT eventually compensate
for and correct any errors during the set-up or filling
operations. Thus, the initial assembly and priming
procedures are of ext reme importance. It is strongly
recommended that personnel responsible for the
equipment’s operation, both assembly and
disassembly, sit down together and go through these
procedures in order to be properly trained and to
make sure that no misunder standings exist.
In the event you should require technical assistance,
please contact your local authorized Taylor
Distributor.
W arranty is valid only if the parts are authorized
Taylor parts, purchased from an authorized Taylor
Distributor, and the required service work is provided
by an authorized Taylor service technician. Taylor
reserves the right to deny warrant y claims on
equipment or part s if non--approved parts or
refrigerant were installed in the machine, system
modifications were perf ormed beyond factory
recommendations, or it is determined that the failure
was caused by neglect o r abuse.
Note: Constant research results in steady
improvements; therefore, information in this
manual is subject to change without notice.
If the crossed out wheeled bin symbol is
affixed to this product, it signifies that this product is
compliant with the EU Directive as well as other
similar legislation in effect after August 13, 2005.
Theref ore, it must be collected separately after its
use is completed, and cannot be dispos ed as
unsorted municipal wast e.
The user is responsible for returning the product to
the appropriate collection facility, as specified by
your local code.
For additional information regarding applicable local
laws, please contact the municipal facility and/or
local d istributor.
Compressor Warranty Disclaimer
The refrigerat ion compressor(s) on this mac hine are
warranted for the term indicated on the warranty
card accompanying this machine. However, due to
the Montreal Protocol and the U.S. Clean Air Act
Amendment s of 1990, many new refrigerants are
being tested and developed, thus seeking their way
into the serv ice industry. Some of these new
refrigerants are being advertised as drop-in
replacement s for numerous applications. It should
be noted that , in the event of ordinary service to this
machine’s refrigeration system, only the refrigerant
specified on the affixed data label should be
used. The unauthorized use of alternate refrigerants
will void your compressor warranty. It will be the
owner’s responsibility to mak e this fact known to any
technician he employs.
It should a lso be noted that Taylor does not warrant
the refrigerant used in its equipment . For example, if
the refrigerant is lost during the course of ordinary
service to this machine, Taylor has no obligation to
either supply o r provide its replacement either at
billable or unbillable terms. Taylor does have the
obligation to recom mend a suit able replacement if
the original refr igerant is banned, obsoleted, or no
longer available during the five year warrant y of the
compressor.
Taylor will continue to monit or the industry and test
new alternates as they are being developed. Should
a new alternate prove, through our testing, that it
would be accepted as a d rop-in replacement, then
the above disclaimer would becom e null and void. To
find out the current status of an alternate refr igerant
as it relates to your compressor warranty, call the
local Taylor Distributor or the Taylor Facto ry. Be
prepared to provide the Model/S erial Number of the
unit in question.