Filter
Top Products
23
Models 8751/8754 Operating Procedures
050201
Step 9
When a steady stream of sanitizing solution is flowing
from the prime plug opening in the bottom of the
freezer door, pull the draw handle down. Draw off all of
the sanitizing solution. (Note: On the Model 8754,
momentarily pull the center draw handle down to
sanitize the center door s pout.)
Figure 38
Step 10
Once the sanitizer stops flowing from the door
spout(s), raise the draw handle(s). Press the WASH
and PUMP keys, cancelling the beater motor and
pump operation.
Figure 39
Note: Be sure y our hands are clean and sanitized
before continuing these instructions.
Step 11
Remove the vinyl sanitizing tube from the air inlet tube
on the air/mix pump.
Step 12
Lubricate the mix feed tube o--rings located on the end
of the tube with the small hole o n the side. Stand the
mix feed tubein thecorner of the mix hopper. Placethe
locking c lip in position in t he outlet fitting of the pump.
Figure 40
Repeat Steps 6 through 12 for the other side of the
freezer on the M odel 8754.
Step 13
Assemble the hopper gasket around the top edge of
the mix hopper.
Priming
Step 1
Place an empty pail beneath the door spout and lower
the draw handle. Be sure the prime plug is still in the
UP position. Pour two gallons (7.6 liters) of fresh mix
into the hopper and allow it to flow into the freezing
cylinder. This will force out any remaining sanitizing
solution. When full strength mix is flowing from the
door spout, raise the draw handle.
Note: Use only fresh mix when priming the
freezer .