Filter
Top Products
28
Models 8751/8754Important: Operator Checklist
j 7. If your machine is equipped with an auxiliary
refrigeration system, check the auxiliary
condenser for accumulation of dirt and lint. Dirty
condensers will reduce the refrigeration
capacity of the mix hopper. Condensers must
be cleaned monthly with a soft brush. Never
use screwdrivers or other metal probes to clean
between the fins.
Caution: Always disconnect
electrical power prior to cleaning the
condenser. Failure to follow this instruction
may result in electrocution.
j 8. If your machineis water cooled, check the water
lines for kinks or leaks. Kinks can occur when
the machine is moved back and forth for
cleaning or maintenance purposes.
Deteriorated or cracked water lines should be
replaced only by an authorized Taylor
distributor.
The Air/Mix Pump Checklist
j 1. Dispose of o-rings and check bands if they are
worn, torn or fit too loosely. Replace t hem wit h
new ones.
j 2. Follow lubricating procedures carefully. Do not
lubricate c heck bands .
j 3. Handle plastic pump parts with care to avoid
nicks and cracks.
j 4. Be sure the air/mix pump is properly attached to
the drive hub, orsevere and costly damagemay
occur.
Winter Storage
If the place ofbusiness is tobe closed during thewinter
months, it is important to protect the freezer by
following certain precautions, particularly if the
building is subject to freezing c onditions.
Disconnect the freezer from the main power source to
prevent possible electrical dam age.
On water cooled freezers, disconnect the water
supply. Relieve pressure on the spring in the water
valve. Use air pressure on the outlet side to blow out
any water remaining in the condenser , and then add a
liberal amount of permanent type auto anti-freeze.
This is extremely important. Failure to follow this
proceduremay causesevere andcostlydamagetothe
refrigeration system.
Your local Taylor Distributor can perform this winter
storage s ervice for you.
Wrap detachable par ts of t he freezer such as beater,
blades, drive shaft, and freezer door, and place t hem
in aprotected dry p lace. Rubber trim parts and gaskets
can be protected by wrapping them with
moisture-proof paper. All parts should be thoroughly
cleaned of dried mix or lubrication which attract mice
and other v ermin.