Filter
Top Products
20
Models 150, 152, 162, 168Operating Procedures
120501
Step 7
Finger- tighten the handscrews, making sure they are
tightened equally and that the door is snug. Do not
over- tighten the hands crews.
IMPORTANT! Handscrew and door damage can
result if the handscrews are over- tightened or if
one handscrew is t ightened more than the other.
Step 8
Slide the two o- rings into the grooves on the draw
valve(s) and lubricate with Taylor Lube.
Figure 19
Note: For the Models 162/168, install the valve seal
in t he grooves on the center draw valve and lubricate
with Taylor Lube. This special s eal will prevent mix
from one freezing cylinder from traveling into the
second cylinder.
Figure 20
Step 9
Lubricate the inside of the freezer door spout(s) from
the bottom. Insert the draw valve(s) into the freezer
door from the bottom.
Figure 21
Note: The draw valve is installed correctly when the
slotted opening in the draw valve is visible through the
“window” of the freezer door.
Figure 22