Filter
Top Products
21
Models 150, 152, 162, 168 Operating Procedures
Step 10
Insert the valve lifter arm through the slotted opening
in the draw valve and align the other end with the cross
holes of the freezer door.
Hint: The valve lifter arm m ay be aligned with the left
or right cross hole. The draw valve handle will be
placed through the opposite cross hole of the valve
lifter arm.
Figure 23
Step 11
Slide the o- ring into the groove on the draw valve
handle and lubricate with Taylor Lube.
Figure 24
Step 12
Insert the draw valve handle through the opposite
cross hole and into the opening of the valve lifter arm.
Hint: The draw valve handle can be assembled at
varied vertical positions. Choose an angle which is
comfortable for you. The draw valve must be raised
completely when the d raw valve handle is down.
Figure 25
Note: For Models 162/168, slide the o- ring onto each
pivot pin and lubr icate with Taylor Lube.
Figure 26