Filter
Top Products
14
Models 358 & 359Operating Procedures
Step 3
Check the scraper blades for any nicks or signs of
wear. If any nicks are present, replace both blades.
If the blades are in good condition, install the
scraper blade clips on the scraper blades. Place the
rear scraper blade over the rear holding pin on the
beater assembly.
Figure 12
Note: The hole on the scraper blade must fit
securely over the pin to prevent costly damage.
Step 4
Holding the rear blade on the beater, slide the
beater halfway into the freezing cylinder. Install the
front scraper blade over the front holding pin. Slide
the beater assembly the rest of the way into the
freezing cylinder.
Figure 13
Step 5
Make sure the beater assembly is in position over
the drive shaft. Turn the beater slightly to be certain
the beater is properly seated. When in position, the
beater will not protrude beyond the front of the
freezing cylinder.
Step 6
Slide the two o-rings into the grooves on the draw
valve and lubricate.
Figure 14
Step 7
Lubricate the inside of the freezer door spout, top
and bottom, and insert the draw valve into the
freezer door from the top (“THIS END UP”).
Figure 15