Filter
Top Products
17
Models 358 & 359 Operating Procedures
Step 6
Stand the air tube in the corner of the mix hopper.
Figure 25
Repeat Steps 1 through 6 for the other side of the
freezer on the Model 359.
Priming
Step 1
With a pail beneath the door spout, raise the draw
handle. Pour two gallons (7.6 liters) of fresh mix
into the mix hopper and allow it to flow into the
freezing cylinder. This will force out any remaining
sanitizing solution. When full strength mix is flowing
from the door spout, lower the draw handle.
Note: Use only fresh mix when priming the freezer.
Figure 26
Step 2
When the mix stops bubbling down into the freezing
cylinder, install the air tube in the mix inlet hole.
Figure 27
Step 3
Place the power switch in the “AUTO” position.
Raise the draw switch to activate the refrigeration
system. When the unit cycles off, the product will be
at serving viscosity.
Figure 28
Step 4
Fill the hopper with fresh mix.