Filter
Top Products
18
Models 358 & 359Operating Procedures
Step 5
Place the mix hopper cover in position over the mix
hopper.
Figure 29
Repeat Steps 1 through 5 for the other side of the
freezer on the Model 359.
Closing Procedure
To disassemble your unit, the following items will be
needed:
S Two cleaning pails
S Sanitized NSF approved stainless steel
rerun can(s) with lid(s)
S Necessary brushes (provided with freezer)
S Cleaner
S Single service towels
Draining Product From the
Freezing Cylinder
Step 1
Remove the hopper cover and the air tube. Take
them to the sink for cleaning.
Step 2
If local health codes permit the use of rerun,
place a sanitized, NSF approved stainless steel
rerun container beneath the door spout. Place the
power switch in the “WASH” position. Raise the
draw handle and drain the remaining product from
the freezing cylinder and the mix hopper. When the
flow of product stops, place the power switch in the
“OFF” position and lower the draw handle. Place a
sanitized lid on the rerun container and place it in
the walk-in cooler.
Note: For additional information regarding the
proper use of rerun, see item 5 on page 21.
Note: If local health codes DO NOT permit the
use of rerun, the product must be discarded.
Follow the instructions in the previous step, except
drain the product into a mix pail and properly discard
the mix.
ALWAYS FOLLOW LOCAL HEALTH CODES.
Repeat Steps 1 through 2 for the other side of the
freezer on the Model 359.
Rinsing
Step 1
Pour two gallons (7.6 liters) of cool clean water into
the mix hopper. With the brushes provided, scrub
the mix hopper, the mix level sensing probe and the
mix inlet hole.
Step 2
With a pail beneath the door spout, place the power
switch in the “WASH” position and raise the draw
handle. Drain all the rinse water from the freezing
cylinder and the mix hopper. When the rinse water
stops flowing from the door spout, lower the draw
handle and place the power switch in the “OFF”
position.
Figure 30
Repeat these procedures until the rinse water
being drawn from the freezing cylinder is clear.
Repeat Steps 1 through 2 for the other side of the
freezer on the Model 359.