Taylor thick shake freezers Freezer User Manual


 
20
Models 358 & 359Operating Procedures
Step 5
Return to the freezer with a small amount of
cleaning solution. With the black bristle brush, brush
clean the rear shell bearing(s) at the back of the
freezing cylinder(s).
Figure 32
Step 6
Remove the drive shaft drip pan(s) from the front
panel and take to the sink for cleaning.
Note: If the drive shaft drip pan is filled with an
excessive amount of mix, refer to the
Troubleshooting Guide.
Step 7
Thoroughly brush clean all disassembled parts in the
cleaning solution, making sure all lubricant and mix
film is removed. Take particular care to brush clean
the draw valve core in the freezer door. Place all the
cleaned parts on a clean dry surface to air dry
overnight.
Step 8
Wipe clean all exterior surfaces of the freezer.