Taylor thick shake freezers Freezer User Manual


 
15
Models 358 & 359 Operating Procedures
Step 8
Place the freezer door gasket into the groove on the
back of the freezer door. Slide the white plastic front
bearing over the baffle rod onto the bearing hub,
making certain the flanged end of the bearing is
resting against the freezer door. DO NOT
LUBRICATE THE GASKET OR THE FRONT
BEARING.
Figure 16
Step 9
Insert the baffle rod through the opening in the
beater and set the door flush with the freezing
cylinder. With the door seated on the freezer studs,
install the handscrews. Tighten the handscrews
equally in a criss-cross pattern to insure the door is
snug.
Figure 17
Step 10
Lay the air tube in the bottom of the mix hopper for
sanitizing.
Figure 18
Step 11
Slide the drive shaft drip pan into the hole in the
front panel.
Figure 19
Repeat Steps 1 through 11 for the other side of the
freezer on the Model 359.
Step 12
Install the front drip tray and splash shield under the
door spout.
Figure 20