Filter
Top Products
SDSFE31xx-100 Industrial Device Server Transition Networks
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
9
DIN rail clip and DIN rail mounting
Mounting the
DIN rail clip
The aluminum DIN Rail Clip should already be mounted to the back panel of the
Device Server. If you need to attach the DIN Rail Clip, position the stiff-metal spring
as shown in Figure 3.
Figure 3: Mounted DIN Rail Clip
DIN rail and
device server
mounting
considerations
Consider the following before mounting the DIN rail to a surface and attaching the
Device Server:
• The surface must support at least 1,000 gm (2.2 lbs) for the Device Server.
• Do not place heavy objects on the Device Server.
CAUTION
Mount the Device Server with proper spacing around it for ventilation (heat
dissipation). Failure to observe this caution could result in damage to the
Device Server.
CAUTION
Please exercise caution when using power tools. Do not install this unit in damp
or wet locations, or in close proximity to very hot surfaces. Failure to observe
this caution could result in damage to the Device Server and cables.
Continued on next page